Official LightBurn Camera Mount

This is a 3D Printed enclosure for the LightBurn 5MP Camera that we sell.  We are using the official design files from LightBurn with their permission, and making these in durable black PETG plastic.

This mount has been designed to better fit all the 5MP cameras we sell, and includes a small interior lip to prevent the camera from sliding. The mount is made to attach to the inside of the lid with 3M double-sided VHB tape, and the camera angle is easily adjusted by loosening the knobs on either side of the mount, and the face plate is held in place by tension clips.

The mount is shipped assembled, including the two bolts and hex nuts needed to set the angle, and VHB tape applied to the base, ready for you to install your LightBurn Camera and mount it to your machine.

You may find that the camera can wiggle a little bit inside the enclosure, and you may want to retain it with a few small drops of RTV Silicone (not included) – make sure that whatever you use is non-conductive!

LightBurn Camera is not included and must be purchased separately.  We also have a Cable Management Kit available for routing the camera cable.

We can also install the camera into the camera mount for you so that you do not have to deal with adhesives and receive a completed unit that is ready to install and use:  LightBurn Camera & Mount Assembly